H3C SR6616 Installation Manual

Also see for SR6616: Installation guide Faq Configuration guide Installation guide Installation, quick start

Contents

H3C SR6616 Installation Manual Manual pdf 155 page image

145LED Status Description(green)Active LEDOff The MCP-X1 is in standby state.Steady on The MCP-X1 is in active state.(red)Powermanagementalarm LEDOff The system power module is normal.Steady on The system power is insufficient.(red)Alarm LEDOff The system is operating correctly and there is noalarm.Steady onA fault has occurred to the system or the availablepower is insufficient. In this state, identify thesystem log immediately.LINK LEDOff The corresponding interface is not connected.Steady green A 1000 Mbps link is present.Steady yellow A 10/100 Mbps link is present.ACT LEDOff No data is being received or transmitted.Flashingyellow Data is being received or transmitted.(yellow/green)SFP+LINK/ACTOff No link is present.Steady green A 10 Gbps link is present.Flashing green Data is being received or transmitted at 10 Gbps.Steady yellow Transceiver module check has failed.(yellow/green)SFP0 throughSFP3Off No link is present.Steady green A 1000 Mbps link is present.Flashing green Data is being received or transmitted at 1000Mbps.Steady yellow A 100 Mbps link is present.Flashingyellow Data is being received or transmitted at 100 Mbps.FIP LEDsFigure 120 FIP-10 LED456789