Page 5-16 400W Series Installation ManualRev. E 190-00356-025.3.13 VOR DISCRETE INPUTS Page (GNS 430WOnly)Select the VOR DISCRETE INPUTS Page (see Figure 5-16).This page allows you to verify the operation of an externalVLOC transfer switch that may be present in the installation.Selection Verify That:REMOTE XFR The box is filled in while a remote VLOC transfer switch is pressed.5.3.14 VOR/LOC/GS CDI Page (GNS 430W Only)Select the VOR/LOC/GS CDI Page (see Figure 5-17).This page allows you to verify and calibrate the CDI outputs,both lateral (LAT) and vertical (VERT) from theVOR/LOC/Glideslope receiver, as well as the OBS resolverinput to the VOR receiver. It also allows you to select the formatfor DME tuning data. Using the controls on the GNS 430Wfront panel, make the selections below and verify the interfacesas appropriate:NOTEThe LAT, VERT, and SELECTED COURSE configurations only apply to installationswhere a CDI/HSI is connected to the VOR/LOC/GLIDESLOPE pins on connectorP4006.CDI (LAT/VERT)Selection Verify That:Max left The CDI is “pegged” to the left/up.Full left The CDI is deflected full scale to the left/up.Std. left The CDI is deflected left of center.Center The CDI is centered.Std. right The CDI is deflected right of center.Full right The CDI is deflected full scale to the right/down.Max right The CDI is “pegged” to the right/down.FLAG (LAT/VERT)Selection Verify That:Hide The LAT/VERT flag is hidden.View The LAT/VERT flag is in view.S-FLG (LAT/VERT)Selection Verify That:Hide The LAT/VERT superflag is hidden.View The LAT/VERT superflag is in view.Figure 5-16. VOR DISCRETEINPUTS PageFigure 5-17. VOR/LOC/GS CDI Page
