400W Series Installation Manual Page 3-7190-00356-02 Rev. ETable 3-4. Pin Contact Part Numbers78-pin conn(P4001)44-pinconn(P4006)25-pin Connector (P4002) Shield GroundConnectorConnectorTypeHigh Density PinContact Standard Density Socket Contact .1-inch Pitch Card-EdgeWire Gauge 22-24 AWG 18 AWG 20-24 AWG 20-24 AWGGarmin P/N 336-00021-00 336-00023-00 336-00022-00 336-00029-00Military P/N M39029/58-360 N/A M39029/63-368 N/AAMP 204370-2 N/A 205090-1 583853-4Positronic M39029/58-360 FC6018D M39029/63-368 N/AITT Cannon 030-2042-000 See Note 2 031-1007-042 N/ANOTES1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subjectto change without notice.2. Alternate contacts for 18 AWG wire: As an alternative to the Positronic contacts listed (andprovided in the installation kit), the installer may use contacts made by ITT Cannon under P/N031-1007-001. These contacts require the use of a different crimp tool positioner than shownin the table, with the part numbers as follows: Daniels P/N K250, Astro P/N 616245, or ITTCannon P/N 980-0005-722.3. For the card-edge connector pin contacts, use AMP part number 90272-1 or equivalentcrimping tool.To prevent a possible short across the pins in the wiring harness, Teflon shrink tubing P/N 312-00005-05,provided in Connector Kit 011-00351-00 (P4002) covers the oversized power and ground pin contactsP/N 336-00023-00 (pins 11, 12, 21, 22) that protrude from the back of the connector shell. Beforecrimping the pins onto the wire:1. Cut the tubing (312-00005-05) into 4 equal lengths.2. Slide a short piece of the tubing over the wire.3. Strip the wire and crimp the pin (336-00023-00) onto the wire.4. Insert the pin into the connector shell.5. Slide the tubing over the exposed portion of the pin and shrink using a heat gun.
