Garmin GNS 430 Pilot's Manual & Reference

Also see for GNS 430: Specification Pilot's manual Instructions Pilot's guide addendum Pilot's guide addendum

Contents

Garmin GNS 430 Pilot's Manual & Reference Manual pdf 66 page image

58Flight Plan Catalog OptionsThe following options (some covered on the preceding pages) are available for theflight plan catalog:Activate Flight Plan? allows you to select the flight plan for navigation guidance, asdescribed on page 56.Invert & Activate FPL? allows you to reverse the highlighted flight plan and selectit for navigation guidance, as described on page 56.Create New Flight Plan? allows you to create a new flight plan, as describedon page 54.Crossfill? allows you to transfer a direct-to destination, the active flight plan, anystored flight plan or user waypoints to a second 400-Series or 500-Series Garminunit. Some crossfill operations can be done automatically. If both units are set to“auto”, a change in the direct-to destination or active flight plan on one unit will alsobe seen on the other. For additional information, please see page 142.To crossfill flight plans between two 400- or 500-Series Garmin units:1. Select the “Crossfill?” option from the flight plan catalog options and press E.2. Rotate the large right knob (d) to select the “Method” field.3. Rotate the small right knob (a) to select “Auto” or “Manual” and press E. “Auto” willautomatically transfer the active flight plan or direct-to selection to another 400- or 500-seriesGarmin unit, without user intervention.4. If “Manual” is selected: Rotate the large right knob (d) to select the “Transfer” field, thenrotate the small right knob (a) to select the type of information to transfer between units(active flight plan, flight plan, all user waypoints or a single user waypoint). When “FlightPlan” or “User Waypoint” is selected, a second field will appear to the immediate right of the“Transfer” field. Use the small (a) and large (d) right knobs to enter the number of theflight plan or the name of the user waypoint you wish to transfer.5. The “Cross-Side” field allows you to designate the sending and receiving units in a crossfilloperation. Rotate the large right knob to select the “Cross-Side” field, then rotate the smallright knob (a), to select “To” or “From”. Press E to confirm the selection.6. Rotate the large right knob (d) to highlight “Initiate Transfer?” and press E.FLIGHT PLANSFlight PlanCatalog Options4qnop