Garmin GNC 420W Pilot's Manual Addendum

Also see for GNC 420AW: Maintenance manual Pilot's guide addendum Quick reference guide Pilot's Guide & Reference Pilot's Guide & Reference

Contents

Garmin GNC 420W Pilot's Manual Addendum Manual pdf 19 page image

17TRFC (White)—Altitude separation >500 feet,steady altitude separationTA (Yellow)—Altitude separation 500 feet,steady altitude separationTRFC (White)—Altitude separation >500 feet,closingPA (White)—Altitude separation 500 feet,openingTRFC (White)—Altitude separation >500 feet,openingTA (Yellow)—Altitude separation 500 feet,closingConfiguring TCAD Data on the Map PageThe display of traffic information closely resemblesthe display symbology used by the Ryan TCAD. Traf-fic data is only displayed on the Map Page if head-ing data is available.You can configure TCAD data on the MapPage using the Map Setup Menu.To configure Traffic on the Map Page:1. Turn the small right knob to select the MapPage.2. Press MENU to display the Page Menu.3. Use the small right knob to select “SetupMap?” and press ENT.4. The flashing cursor highlights the GROUP field.Turn the small right knob to display the MapSetup Options Menu. Turn the small rightknob to select Traffic and press ENT.5. Turn the large right knob to select the desiredTraffic Mode option. Turn the small right knobto select the desired option and press. Repeatthe step for Traffic Symbol and Traffic Label.6. Return to the Map Page by pressing CLR.The Map Page has the ability to display traffic ina thumbnail format in any of the top three fields (topfour fields on a 500W Series unit) on the right-handside of the Map Page.To display Thumbnail Traffic on the MapPage:1. Turn the small right knob to select the MapPage.2. Press MENU to display the Page Menu.3. Use the small right knob to select “ChangeFields?” and press ENT.4. Select one of the top three fields (top fourfields on a 500W Series unit). Select TRFCfrom the Select Field Type List and press ENT.Note that the thumbnail range defaults to 6NM and cannot be changed for TCAD 9900BXand slaves to the current shield size for TCAD9900B.Section 4Ryan TCAD Interface