Garmin Apollo CNX80 Installation Manual

Also see for Apollo CNX80: User Newsletter User Newsletter Supplemental Flight manual Pilot's guide Data list

Garmin Apollo CNX80 Installation Manual Manual pdf 42 page image

Installation Procedures2-12 560-0982-00 Rev D Apollo CNX80 Installation ManualFigure 2-4 - Typical Mounting Rack2.6.1.3 Mounting Tube Cable RoutingAfter the cable assemblies are made and wiring installed to the mounting tube back plate, route wiringbundle as appropriate.Use tie wraps to secure the cable assemblies and coax to the holes provided in the bottom of the connectorplate to provide strain relief for the cable assemblies. The cable shields should be grounded directly to a lugmounted to one of the holes on the bottom of the connector plate, keeping the ground leads to a maximumof 3 inches long.2.6.2 U NIT INSERTIONPosition the cam lock as shown below. The front lobe of the cam should be vertical. The cam lockmechanism should be fully unscrewed (turned counter-clockwise). Slide the unit into the frame. Turnclockwise and carefully tighten (15 in-lb max.) the cam lock mechanism using a 3/32" hex driver. The unitwill be pulled into the frame, securing the unit and connectors when fully engaged. Do NOT overtighten.The back of the bezel must be flush to the mounting tube (within 0.020"). If the cam lock is hard to turn orthe unit does not seat fully, the unit is probably binding and the mounting tube should be checked.