GE ZVC36LSS Installation Instructions Manual

Also see for 36" CUSTOM HOOD INSERT ZVC36LSS: Dimensions and installation information Owner's manual Installation instructions Installation instructions

Contents

GE ZVC36LSS Installation Instructions Manual Manual pdf 5 page image

Design InformationPRODUCT DIMENSIONSZVC30 Dimensions and Specifications (in inches)Outside Dimensions27-1/2_The custom canopg must be sized to fit the insertsleeve. Construct the canopg with an openingthat is:26"W x 13-3116"DThe opening must be constructed of 3/4" thickmaterial to allow the sleeve locking clips toengage.The Supplied Liner28-1/2"21-1/4"The stainless steel liner is shipped with each hoodinsert. This non-combustible liner protects theunderside of the canopg,Custom LinerIf gou are not using the supplied liner, gou mugconstruct a custom non-combustible liner. Use thesupplied liner as a template. The opening must be26'MI x 13-3116"D. 3/4" thick material mustsurround the opening to allow the sleeve lockingclips to engage. The insert sleeve inside the cabinetshould be positioned 1/2" from the rear wall sothat the center of the 8" duct is 5-1/2" from therear wall.'2"The Insert Sleeve251:,1/2"The bottom edge of the insert sleeve has a 7/8"wide flange on the sides and a 1/2" wide flangeon the front and back.Remote Location for the ControlThe control may be removed from the hoodand installed into a wall or countertop, A 30-ft.length of wire is supplied to accommodate mostinstallations. A blanking plate covers the openingwhen the controls are removed.The overall size of the control is 4-114" wide and2-1/4" deep.41-11116"3-11/16"Control cutout1/2"We recommend that the cutout in granite or otherhard surfaces be made before the countertop isinstalled.