GE 36" CUSTOM HOOD INSERT ZVC36LSS Dimensions And Installation Information

Also see for 36" CUSTOM HOOD INSERT ZVC36LSS: Owner's manual Installation instructions Installation instructions Installation instructions

Contents

outside dimensions

GE 36" CUSTOM HOOD INSERT ZVC36LSS Dimensions And Installation Information Manual pdf 1 page image

ZVC36LSSGE Monogram ® 36" Custom Hood InsertFor answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center® service,800.626.2000.Specification Created 10/06Custom Insert LinerThe custom canopy must be sized to fit the insert sleeve.Construct the canopy with an opening that is:26"W x 13-3/16"DThe opening must be constructed of 3/4" thick material toallow the sleeve locking clips to engage.Dimensions and Specifications (in inches)Outside DimensionsThe Insert SleeveThe bottom edge of the insert sleeve has a 7/8" wide flangeon the sides and a 1/2" wide flange on the front and back.Remote Location for the ControlThe control may be removed from the hood and installedinto a wall or countertop. A 30-ft length of wire is supplied toaccommodate most installations. A blanking plate covers theopening when the controls are removed. The overall size ofthe control is 4-1/4" wide and 2-1/4" deep.1-11/16"3-11/16"We recommend that the cutout in granite or other hardsurfaces be made before the countertop is installed.The Supplied LinerA stainless steel liner is shipped with each hood insert. Thisnon-combustible liner protects the underside of the canopy.Custom LinerIf you are not using the supplied liner, you may construct acustom non-combustible liner. Use the supplied liner as atemplate. The opening must be 26"W x 13-3/16"D. 3/4" thickmaterial must surround the opening to allow the sleevelocking clips to engage. The insert sleeve inside the cabinetshould be positioned 1/2" from the rear wall so that thecenter of the 8" duct is 5-1/2" from the rear wall.130674

/ 2

Related manuals for GE 36" CUSTOM HOOD INSERT ZVC36LSS