GE Monogram ZDP304NPSS Owner's Manual

Also see for 36 Ceramic Cooktop: Owner's manual Owner's manual Use and care guide Use and care guide Owner's manual

GE Monogram ZDP304NPSS Owner's Manual Manual pdf 32 page image

Care and CleaningProfessional Dual Fuel RangeOven lights CAUTION: Before replacing a bulb,disconnect electrical power to the oven at themain fuse or circuit breaker panel.Each oven is equipped with halogen light columnslocated on the side walls of the oven. The lightscome on when the door is opened or when theoven is in a cooking cycle.Each light assembly consists of a removable lightcover with two locking clips and a light compartmentwith three halogen bulbs.Be sure to let the light cover and bulb coolcompletely. For your safety, do not touch ahot bulb with bare hands or a damp cloth.To remove:1. Remove the racks from the oven. See theFull extension oven racks section.2. Using a 7/16″ nutdriver, remove the four nutsholding the rack supports to the oven wall.3. Remove the glass light cover by pulling its backedge out and rolling it toward you. Do notremove any screws.4. Using gloves or a dry cloth, remove theburned-out light bulb by pulling it straight out.To replace:Use a new 120-volt Halogenbulb, with G8 pins, not toexceed 25 watts.Replacement bulbs may be purchased by calling800.626.2002. Order Part Number WB25T10064.NOTE: Higher wattage bulbs will damage your oven.Using gloves or a dry cloth, remove the bulbfrom its packaging. Do not touch the bulb withbare fingers. Oil from bare fingers may cause hotspots on the glass surface and lead to prematurefailure of the bulb. If you do touch the glass, cleanit with alcohol prior to installation.1. Push the bulb straight into the receptacleall the way.2. Replace the light cover, by placing itsfront edge under the front two tabs in the lightcompartment. Roll the back edge into place,making sure that it is firmly seated.NOTE: If the locking clips fell from the glass lenscover, hold them on the cover, in the correctposition, while replacing the cover on the lightcompartment.The light cover must be in place when usingthe oven.3. Reinstall the rack support. Be sure to orient thesupport so that the top tabs for the nuts areclosest to the top of the oven. Lightly securewith the four nuts removed earlier, but do notover-tighten or the enamel could be chipped.4. Replace the racks. See the Full extension ovenracks section.5. Reconnect electrical power to the oven.LockingclipsPress the light cover into placePlace frontedge oflens coverunderfront twotabs32