GE JS998 Owner's Manual

Also see for JS998 Series: Installation instructions Owner's manual Owner's manual Owner's manual Owner's manual

GE JS998 Owner's Manual Manual pdf 44 page image

Care and cleaning of the range.44Clean the oven racks and the convectionroasting rack with an abrasive cleanser orsteel wool. After cleaning, rinse the rackswith clean water and dry with a cleancloth.NOTE: The oven racks and convection roastingrack may be cleaned in the self-cleaning oven.However, the oven racks will darken in color,lose their luster and become hard to slide ifcleaned during the self-cleaning cycle.To make the oven racks slide more easily,apply a small amount of cooking oil to apaper towel and wipe the edges of theoven racks with the paper towel.Oven Racks and Convection Roasting RackRoasting rackOven rackConsumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsPainted SurfacesPainted surfaces include the door,top of the control panel and the drawerfront. Clean these with soap and water ora vinegar and water solution.Do not use commercial oven cleaners,cleaning powders, steel wool or harshabrasives on any painted surface.Oven Light BulbsNOTE: The glass cover should beremoved only when cold. Wearing latexgloves may offer a better grip.CAUTION: Before replacing youroven light bulb, disconnect the electricalpower to the oven at the main fuse orcircuit breaker panel.Be sure to let the light cover and bulbcool completely.For your safety, do not touch a bulb withbare hands or a damp cloth. It can alsoshorten the bulb life.To remove:Turn the glass covercounterclockwise 1/4 turn until thetabs of the glass cover clear thegrooves of the socket.Using gloves or a dry cloth, removethe bulb by pulling it straight out.To replace:Use a new 130-volt Halogen bulb,not to exceed 50 watts.Using gloves or a dry cloth, removethe bulb from its packaging. Do nottouch the bulb with bare fingers.Push the bulb straight into thereceptacle all the way. Then replacethe screen.NOTE: The screen must be replaced orthe life of the bulb will be reduced.Place the tabs of the glass cover intothe grooves of the socket. Turn theglass cover clockwise 1/4 turn.For improved lighting insidethe oven, clean the glass coverfrequently using a wet cloth. Thisshould be done when the oven iscompletely cool.Reconnect electrical power tothe oven.BulbSocketTabGlass coverReceptacleUse glovesor clothReceptacleScreen