GE JGBS10 Owner's Manual & Installation Instructions

Also see for JGBS09: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

GE JGBS10 Owner's Manual & Installation Instructions Manual pdf 35 page image

ASSEMBLE SURFACE BURNERSAssemble the side burners as shown.Assemble the center burner. Make sure thatthe locking feet on the center grate hookover the side grates.CAUTION: Do not operate the burnerwithout all burner parts in place.Place the burner heads and caps on thecooktop. Make sure that the heads and capsare placed in the correct locations. There isone oval (center) head and cap assemblyand four medium (side) heads and caps.BA535Installation InstructionsELECTRICAL CONNECTIONS (CONT.)Usage Situations where Appliance PowerCord will be Disconnected Frequently.Do not use an adapter plug in these situationsbecause disconnecting of the power cord placesundue strain on the adapter and leads toeventual failure of the adapter ground terminal.The customer should have the 2-prong wallreceptacle replaced with a three-prong(grounding) receptacle by a qualified electricianbefore using the appliance.The installation of appliances designed formobile home installation must conform withthe Manufactured Home Construction andSafety Standard, Title 24 CFR, Part 3280(formerly the Federal Standard for MobileHome Construction and Safety, Title 24, HUD,Part 280) or, when such standard is notapplicable, the Standard for ManufacturedHome Installations, latest edition (ManufacturedHome Sites, Communities and Set-Ups), ANSIA225.1, latest edition, or with local codes.Electric Disconnect• Locate disconnect plug on the range back.• Pinch sides of connector and pull out of rangeback.B3SEAL THE OPENINGSSeal any openings in the wall behind the rangeand in the floor under the range when hookupsare completed.4Medium burnerhead and capFront of rangeMedium burnerhead and capMedium burnerhead and capMedium burnerhead and capOval head and capassemblySlotElectrodeSlotBurner capBurner headSideGrateElectrodeBurner headand capassemblyCenter GrateElectrodeLockingFootLockingFootMake sure the slot in the burner head ispositioned over the electrode.