Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsCare and cleaning of the range.Be sure all controls are off and all surfaces are cool before cleaning any part of the range.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is re-engaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Control PanelDeactivate the touch pads before cleaning.See the Cooking/Self-Clean lockoutinformation in the Special features ofyour oven control section in this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapywater. Do not use abrasives of any kind.Reactivate the touch pads after cleaning.See the Cooking/Self-Clean lockoutinformation in the Special featuresof your oven control section in thismanual.Oven VentThe oven vent is located behind the right rearsurface unit.This area could become hot duringoven use.It is normal for steam to come outof the vent and moisture may collectunderneath it when the oven is in use.The vent is important for proper air circulation.Never block this vent.528How to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Do notuse any sharp items to remove the film.Remove all of the film before using theappliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packaging tapeon new appliances is an application of ahousehold liquid dishwashing detergent.Apply with a soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.Control KnobsThe control knobs may be removed for easiercleaning.Make sure the knobs are in the OFFpositions and pull them straight off thestems for cleaning.The knobs can be cleaned in adishwasher or they may also be washedwith soap and water. Make sure the insideof the knobs are dry before replacing.Replace the knobs in the OFF position toensure proper placement.