CARESCAPE PDM6. Wipe off the cleaning solutions with a clean, lightly moistened cloth.7. Visually ensure that the device is clean. If visible soil remains, repeat cleaningprocedure until the device is thoroughly clean.8. Dry thoroughly with a dry, lint-free cloth and let air dry for at least 30 minutes.Drying times may vary based on the environmental conditions.9. Install the battery and close the battery door.10. Reconnect all cables.11. Reconnect the device to the host.Battery compartment cleaningNOTICE The battery compartment is not waterproof.NOTICE Make sure fluids do not enter the electronics through the airholes in the battery compartment floor.NOTICE Cleaning the battery compartment in a manner other thanthat specified may cause the unit to malfunction and voidthe warranty.Under normal conditions, the battery compartment should not require cleaning. If thebattery compartment does require cleaning, then use the following instructions.1. Remove the battery from the battery compartment.2. Dampen a soft lint-free cloth with one of the permitted detergents.3. Wring excess liquid from the cloth and wipe the interior of the batterycompartment. Make sure moisture does not enter the electronics area belowthe battery compartment floor.4. Wipe off the cleaning solutions with a clean, lightly moistened lint-free cloth.5. Dry thoroughly with a soft lint-free cloth. Allow the battery compartment to air drycompletely prior to closing the compartment door.Drying times may vary based on the environmental conditions.6. Install the battery and close battery door.Other manufacturer cleaning instructionsFor details about cleaning and disinfection information for devices, devicecomponents, supplies, and accessories made by manufacturers other than GE, seethe applicable instructions for use provided by the manufacturer.Do not reuse single-use disposable accessories.2110145-001 Cleaning and disinfecting 13