XG Series User's Guide Chapter 5 Command ReferencePort Information Settings137[XG0224 / XG0448 / XG0440DC / XG0440DCR]Note 3.This command is unavailable if the allowable upper limit for the device is exceeded.The allowable upper limits are as follows.• Upper limit based on "commands"128 commands for the entire device.Up to 128 commands can be set for the entire device, including the "ether macfilter","vlan macfilter" and "lan ip filter" commands.The priority for each command is as follows.1) "ether macfilter" commandA smaller Ethernet port number has a higher priority among Ethernet ports.2) "vlan macfilter" commandA smaller VLAN ID has a higher priority among VLANs.3) "lan ip filter" commandA smaller lan definition number has a higher priority among lans.If up to 128 of "ether macfilter" commands have been defined for port ether1, thesubsequent "vlan macfilter" and "lan ip filter" command will be no longer applied.• Upper limit based on rule128 rules for the entire device.For the "ether macfilter", "vlan macfilter" and "lan ip filter" commands, the number ofrules to be used varies depending on the contents of the specified acl as shown below.The number of rules for each ACL is as follows.- For ACL to set TCP or UDPResult of multiplication between the number of source ports and the number ofdestination ports for TCP or UDP- For ACL to set ICMPResult of multiplication between the number of ICMP TYPEs and the number ofICMP CODEs for ICMP- For ACL not to set TCP, UDP, or ICMP1You can expand the upper limit to use "resource filter distribution" command andchange resource distribution.Note 4.Up to 800 commands can be set for the entire device, including the definitions whichIt is assumed that this option has not been set.refer to ACL such as "ether macfilter","ether qos aclmap", "vlan macfilter", "vlan ip6filter", "vlan qos aclmap", "vlan ip6qosaclmap", "lan ip filter", "lan ip dscp", "lan ip6 filter", "lan ip6 dscp" and "serverinfo filter"commands.Note 5.When the port type of the Ethernet port is a link aggregation, set it only to the anchor portwhere the link aggregation is composed.Default It is assumed that this option has not been set.
