XG Series User's Guide Chapter 5 Command ReferencePort Information Settings1045.1.1.13 ether loopdetect frameFunction Enable the Loop Detection Frame sender.Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600Syntax ether loopdetect frame Options• ether port numberSet a port number to use with a decimal value.When setting multiple port numbers, separate them with commas (,).When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")Set the sender of loopdetect-frame.• ownA Loop is detected when receiving a Loop Detection frame from this device.• anyA Loop is detected when receiving a Loop Detection frame from any device.Use Mode Configuration mode (admin class)Explanation Specify the sender of Loop Detection frames used to detect a loop.The following is the port which is blocked/offlined when a loop is detected.Default It is assumed that set the sender as own. Sender of Loop Detection frame The port which is blocked/offlinedown This device The port reporting the Loop Detectionframeany This device The port reportinging the Loop DetectionframeOther device The port receiving the Loop Detectionframeether loopdetect frame own
