Fujitsu Stylistic 3400 Assembly And Use Instructions

Also see for Stylistic 3400: User guide User guide Installation guide User guide Operating instructions

FUJITSU PC CORPORATIONStylistic 3400 is a trademark of Fujitsu PC Corp. © 2000 Fujitsu PC Corp.4/00 Page 1 of 4 58-0710-00AFMW42CR3Wall-Mount CradleAssembly and Use InstructionsStylistic 3400The Stylistic 3400 wall-mount cradle is designed toprovide a convenient, secure, hands-free station foryour pen tablet and keyboard.The wall-mount cradle uses high-usage DC Inputand Universal Serial Bus (USB) contact pins toconnect to the pen tablet. The USB pins are used forinterfacing with the USB keyboard. (Note that theseconnectors are not visible or accessible when thewall-mount cradle is installed.)Assembly Instructions 0The Stylistic 3400 wall-mount cradle is shippedpartially disassembled. Follow the instructionsbelow to assemble the unit. Note that theseinstructions are for the assembly of the cradle, notfor mounting the cradle. The mounting andelectrical connection of the cradle are determined bylocal procedures.Parts Included 0Verify that all parts and tools listed below arepresent before proceeding with the assembly.Table 1: Parts Included in Wall Mount KitAdditional Parts Required 0In order to use the wall mount cradle mosteffectively, it is necessary for you to purchase thefollowing parts from an authorized reseller.Quantity Part1 Wall Mount Back Assembly1 Wall Mount Tray Assembly1 Cradle Assembly (plastic)2 Keys1 Hardware Kit, consisting of:6 Screws (short, black)4 Screws, Phillips(black, with star lockwasher)2 Screws (silver)2 Flat Washers2 Ty-Wraps TMTable 2: Additional Parts Required*The "x" in the part numbers in Table 2 refers to the suffixassociated with the localized version of keyboard or AC Adapter.Tools Required 0The proper assembly of the wall mount cradlerequires the use of the following common tools.Table 3: Tools RequiredInstalling the Cradle 01. Lay the wall mount back assembly on yourwork surface.2. Position the cradle assembly over the backassembly so that the four screw holes in thecradle align with the holes in the back assembly.Ensure that the circuit card and cable extendfrom the bottom of the cradle (reference Fig. 1).Figure 1. Mounting the Cradle to the Back AssemblyQuantity Part1 USB Keyboard (FMWKB5x)*1 AC Adapter (FMWAC6x)*Tool DescriptionScrewdriver PhillipsWrench Allen, 3/32Pliers CuttingCircuit CardCradle Assembly ScrewsWall Mount Back AssemblyStandoffs

/ 4

Related manuals for Fujitsu Stylistic 3400