5.7.2 Operation Volume CreationCreate volumes (areas in the drives of a RAID group) in the RAID group.Create a 1TB Standard volume in the operation RAID group created in "5.7.1 RAID Group Creation" (page 49).Figure 5.6 Operation Volume CreationOperation RAID group (RG0)Operation volumeRAID1+0 (2+2)main(Standard)1TB1.6TB1.6TB1.6TB1.6TBTo perform backup with SnapOPC+, two types of volume for backup (generation data management area andtemporary work area) must be prepared in addition to the one for operation. For details about creation ofbackup volume, refer to "5.7.3 Generation Management Volume (SDV) Creation" (page 53) and "5.7.4 Tem-porary Work Volume (SDPV) Creation" (page 54).Table 5.2 Operation Volume CreationUsage Item Capacity Volume typeOperation volume (copysource)main 1TB StandardGeneration management vol-umesdv0 - 6 1TB (*1) Snap Data VolumeTemporary work volume sdpv 500GB Snap Data Pool Volume*1: Though the copy source capacity is specified during creation, the capacity allocated to sdv is approxi-mately 0.1% of the copy source capacity.When creation is finished, the volume is automatically formatted. After volume creation, Standard andSDV become accessible from the host when host affinity setting is completed.SDPV becomes available when formatting starts after creation.The procedure to create an operation volume is as follows:1 Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.The [Volumes] screen appears.Chapter 5 General Settings5.7 RAID Configuration Settings51FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)Copyright 2014 FUJITSU LIMITEDP3AM-8462-01ENZ0
