Menu
Fujitsu ETERNUS DX200F Setup Manual
Also see for Eternus DX200F: Configuration guideConfiguration guideConfiguration guideSafety precautionsConfiguration guide
         |
Setup GuideSetup GuideFUJITSU StorageETERNUS DX200F All Flash ArrayP3AM-8482-01ENZ0An installation space and network environment must be prepared in advance.Prepare the following manuals:● Manuals for the ETERNUS DX200F All Flash Array● Related manuals, such as manuals for the server or the networking equipment that is usedInstallation SpaceSite Planning GuideNetwork Environment• Configuration Guide (Basic)• Configuration Guide (Web GUI)PreparationSTEPInstallation spaceCheck that the installation area meets the space requirements of the rack in which the ETERNUS DX200F All FlashArray (hereafter referred to as "ETERNUS DX") is to be installed.Environmental considerations for installationCheck if the installation area for the ETERNUS DX meets the environmental conditions and installation environmentconditions.Power outletsCheck the type and the number of power outlets/sockets that are required to install the ETERNUS DX.Completing and attaching the Network Settings labelWrite down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.Settings for the PC● Setup Network Environment- IP address : 192.168.1.2- Subnet mask : 255.255.255.0● Set the Web browserRefer to "Configuration Guide (Web GUI)" for details on the settings that are required. |
Related manuals for Fujitsu Eternus DX200F
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved