6 Shut down the server.After this, the settings for the ETERNUS DX must be completed before connecting the ETERNUS DX tothe server. In order to perform these settings, turn off the server.3.3 Preparing the PC Terminal for SetupThe initial settings are performed by using a Web browser on the PC terminal.Prepare and set up the PC terminal before the initial settings.Preparing the PC terminalPrepare the PC terminal that contains the following environment:• Web browserUsable Web browsers are shown below. Using Web browsers other than the following is possible, but prop-er operation is not guaranteed.- Microsoft Internet Explorer 7.0, 8.0, 9.0, 10.0 (desktop version), 11.0 (desktop version)- Mozilla Firefox 3.6.x, ESR 10.0.x, ESR 17.0.x, ESR 24.0.xSetting up the PC terminalSet up the PC terminal with the following procedure:1 Set the IP address and subnet mask of the PC terminal.Set the following values.IP address: 192.168.1.2Subnet mask: 255.255.255.02 Check the settings of the Web browser.For details on the required settings, refer to "Configuration Guide (Web GUI)".Chapter 3 Checking the Configuration Environment3.3 Preparing the PC Terminal for Setup27FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)Copyright 2014 FUJITSU LIMITEDP3AM-8462-01ENZ0
