Fujitsu ETERNUS CS800 S6 User Manual

Also see for ETERNUS CS800 S6: Quick start up guide

Contents

8.3 VTL WizardFigure 105: VTL Wizard: AboutStep 2: Add Partition1. Under Partition Settings, enter information about the partition (see "VTL Wizard: AddPartition" on page 142).Name Enter the name of the VTL partition.Library Model Select the library model emulated by the partition.The library model determines the inquiry stringreturned to the host by the ETERNUS CS800.The following library models are available:l Fujitsu CS-TLl ADIC Scalar 100, ADIC Scalar i2000, or ADIC Scalari500l ADIC Pathlight VXNumber of Storage Slots Accept the default number of storage slots(based onmodel), or enter the number of storage slots in thepartition (up to 9,000).One I/E slot is created for each storage slot up to amaximum of 240 I/E slots.Virtual Tape Drive Model Select the tape drive model emulated by the virtualdrives in the partition. All virtual tape drives in apartition must be the same model.The following tape drive models are available:l IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5l HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5ETERNUS CS800 141