Canon imagePROGRAF iPF5000 Series Service Manual

Also see for iPF5000 - imagePROGRAF Color Inkjet Printer: Troubleshooting guide Troubleshooting guide Brochure & specs Brochure Information sheet

Contents

Canon imagePROGRAF iPF5000 Series Service Manual Manual pdf 134 page image

Chapter 44-32F-4-90b) Procedure after replacing the head management sensorSince the distance between the head management sensor and the carriage unit varies among printers, the optical axis is factory-adjusted to adjust the non-dischargingdetection position. When you have replaced the head management sensor or performed assembly/reassembly of surrounding parts that can change the distance be-tween the head management sensor and the carriage unit, reasjustment is required.Peform the readjustment in the service mode.Service mode : SERVICE MODE > ADJUST > NOZZLE CHK POS.4.3.14 Multi Sensor 0012-6402Removing the multi sensor1) Remove the screw[1], disconnect the flexible cable[2], and then remove the multi sensor[3].F-4-91Since multi sensors have individual electrical specificity, the following are recalibrated at the factory, namely, the optical axis of the sensor, the sensor gain formeasuring the printhead height and color reproduction. Accordingly, carry out the following adjustments in the service mode whenever replacing the carriage unitor multi sensor.* The multi sensor reference plate must be replaced at the same time whenever the carriage or the multi sensor is being replaced.* When replacing the carriage unit, refer to Adjustment and Setup > Procedure after Removing or Replacing the Carriage Unit.- Service mode : SERVICE MODE > ADJUST > GAP CALIB- Service mode : SERVICE MODE > ADJUST > SENSOR CALIBTest chart : CL-7( Tool No. : FY9-9323 Use anew chart.)- Service mode : SERVICE MODE > ADJUST > PRINT PATTERN > OPTICAL AXISMedia type : Photo glossy paperMedia size : Media having a width equal toor larger then that of A2-size paper[3] [2][1][2] [3][1][1]