Chapter 22-152.2.5 Connecting the Cable 0007-5059iR2270 / iR2870 / iR3570 / iR45701) If you are installing a cassette pedestal, remove thelattice connector cover, and fit the lattice connector[1] of the cassette pedestal to the machine.F-2-402) Connect the power plug to the power outlet.1. Power supply voltage shall be +/-10% of the rating.2. The amperage of the power supply must be as rated.3. Before connecting the power plug, check to be surethat the main power switch is off.3) Turn on the main power switch.- The machine issues a message to indicate that it isloading programs.- The machine issues a message to indicate that itsprinter is getting ready for a job.Turning Off the Main PowerWhenever you have to turn off the main power, besure to go through the following to avoid damage tothe hard disk:1. Hold down the control panel power switch for 3 secor more.2. Go through the instructions for the shut-downsequence shown on the display so that the main powerswitch may be turned off.3. Turn off the main power switch.2.2.6 Stirring Toner 0007-5062iR2270 / iR2870 / iR3570 / iR45701) Enter the Service Mode. (Press "*" first, and "2"and "8" at the same time, and then "*.")2) Select COPIER >FUNCTION > INSTALL>TONER-S.3) Press the OK key.- Toner stirring time is approx. 6 minutes. Aftercounting up, it stops automatically.- Make the cassette settings before toner stirring iscompleted. (See Setting the Cassettes.)2.2.7 Setting the Cassettes 0007-5065iR2270 / iR2870 / iR3570 / iR45701) Press the cassette release button, and draw out thecassette to the front.2) Check the paper series that the user is going to use,and verify whether or not the paper series selectionswitch [1] in the cassette matches that of the user'sselection. If not, change the paper size series to theappropriate one.3) Set the paper size selection dial [2] to the paper sizeof the paper to be placed.[1]
