Chapter 1313-113.1 Image Adjustments13.1.1 Standards for ImagePosition 0007-4812iR2270 / iR2870 / iR3570 / iR4570A print made at a magnification of 100% must meetthe following standards for image margin/non-imagewidth:- Margin Along the Leading EdgeF-13-1- Left/Right Image MarginF-13-2- Leading Edge Non-Image WidthF-13-3- Left/Right Non-Image WidthF-13-413.1.2 Adjusting the ImagePosition 0007-4813iR2270 / iR2870 / iR3570 / iR4570Using the source of paper indicated, make 10 printseach to see if the image margin and the non-imagemargin are as indicated:[1] Cassettes[2] Manual feed tray[3] Side paper deckIf not as indicated, adjust the image position asfollows:1.Adjusting the Leading Edge Image Margin (1stside)Adjust the registration in service mode:COPIER > ADJUST > FEED-ADJ > REGISTF-13-52. Adjusting the Left/Right Image (1st side)Mechanical Horizontal Registration Adjustment3. Adjusting the Leading Edge Image Margin (2ndside)Adjust the registration in service mode:2 54 6 8 10 12 14 16 18 2002.5 1.5mm2nd side of double-sided copy2.5 2.0mm108654202.5 1.5mm2nd side of double-sided copy2.5 2.0mm2 54 6 8 10 12 14 16 18 2002.5 1.5mm2nd side of double-sided copy2.5 1.5mm108654202.5 1.5mm2nd side of double-sided copy2.5 1.5mmPaperleading edgeDecrease the REGIST setting.(a decrease of '10' willincrease the margin by 1 mm)Increase the REGIST setting.(an increase of '10' willincrease the margin by 1 mm)2 54 6 8 10 12 14 16 18 2001st side of copy : 2.5 1.5mm
