Chapter 1616-4616.5 FUNCTION （Operation/Inspection Mode）16.5.1 COPIER16.5.1.1 Copier List 0007-9317iR2270 / iR2870 / iR3570 / iR4570T-16-31COPIER > FUNCTION > INSTALLSub-item Description LevelTONER-SStirring toner in the developer at installation11. Select an item to reverse its display.2. "Check the Developer" is displayed.Check that the developer connector is connected.3. Press the OK key to start operation. The operation automatically stopsafter count-down."Check the Developer" is displayed to prevent the connector from beingdisconnected when the developer is replaced. Therefore, this message isnot necessary when the machine is shipped with the developer forinstallation.STRD-POSAutomatically adjusting the CCD read position at flow read- This is necessary when DF is installed and when ADF is removed andmounted again.11) Select an item to reverse its display. Then press the OK key.- Adjustment automatically starts and stops.2) Since the value is updated in the service mode,COPIER>ADJUST>ADJ-XY>STRD-POSenter the value into the servicelabel.CARD Installing and setting the card reader1Enter the card number (1 to 2001) and press the OK key. (One thousandcards can be used from the input card number.)Then the card management information (department ID and PIN) isinitialized.E-RDS for future expansion 1
