Chapter 1515-31- HD-CLEARWhen you have executed HD-CLEAR, all contents of the partition in question (files, sub directories) will be lost.The actual formatting will take place when the machine is started up after it has been turned off upon execution ofHD-CLEAN.At this time, the Startup screen shows a progress bar, its edge reaching the end in about 5 min. Be sure not to turnoff the power while the progress bar is moving.This function (i.e., mode item) cannot be used for BOOTDEV and DOSDEV4; to re-format any of these 2 partitions,you will have to use the SST.Keep in mind that formatting of the HDD in service mode will necessarily be full formatting.- HD-CHECKIf the power is cut while data is being written to the HDD, the occurrence of a write-suspended sector is a possibility.*11 13, 25 The ongoing write operationhas been suspended.There is a likelihood of the presence ofdamage to the file data on the HDD (e.g.,Box).1. Set '0' for TYPE-TYPE, and executeHDD-CHECK (40 to 50 min). Thereafter,turn off and then back on the power.2. If the symptom still exits after theforegoing, set '1' for TYPE-TYPE, andexecute HDD-CLEAR.(In the case of DOSDEV4 or BOOTDEV,execute formatting and re-installation onceagain.)3. If the symptom still exists after theforegoing, suspect a fault on the HDD, andreplace the HDD and re-install the systemsoftware.*12 10, 12, 14,22, 23, 24There is a system error or apacket data error.The data may be corrupted or there is asoftware bug.1. Start up in safe mode, and execute fullformatting using the SST and re-install thesystem software (System, Language,RUI). Thereafter, turn off and then back onthe main power.2. If the symptom still exits after theforegoing, suspect a fault on the HDD, andreplace the HDD and re-install the systemsoftware.YY Description Remedy
