Chapter 88-38.4 Sevice Call Table8.4.1 Service call errors 0013-2081*Codes correspond to the numbers shown on the DIPLAY in the service mode.T-8-403810202-2582 Remaining ink low (M)03810202-2592 Remaining ink low (M)03810203-2583 Remaining ink low (C)03810203-2593 Remaining ink low (C)03810204-2580 Remaining ink low (BK)03810204-2590 Remaining ink low (BK)03810206-2586 Remaining ink low (MBK)03810206-2587 Remaining ink low (MBK2)03810206-2596 Remaining ink low (MBK)03810206-2597 Remaining ink low (MBK2)03830101-2521 Ink tank not installed (Y)03830102-2522 Ink tank not installed (M)03830103-2523 Ink tank not installed (C)03830104-2520 Ink tank not installed (BK)03830106-2526 Ink tank not installed (MBK)03830106-2527 Ink tank not installed (MBK2)03830201-2541 Ink tank ID error (Y)03830202-2542 Ink tank ID error (M)03830203-2543 Ink tank ID error (C)03830204-2540 Ink tank ID error (BK)03830206-2546 Ink tank ID error (MBK)03830206-2547 Ink tank ID error (MBK2)03830301-2561 Ink tank EEPROM error (Y)03830302-2562 Ink tank EEPROM error (M)03830303-2563 Ink tank EEPROM error (C)03830303-2572 Remaining ink low (M)03830304-2560 Ink tank EEPROM error (BK)03830304-2570 Remaining ink low (BK)03830306-2566 Ink tank EEPROM error (MBK)03830306-2567 Ink tank EEPROM error (MBK2)03830306-2576 Remaining ink low (MBK)03830306-2577 Remaining ink low (MBK2)03830312-2571 Remaining ink low (Y)03830313-2573 Remaining ink low (C)03841001-2819 Maintenance cartridge tank full03841001-281B Empty capacity of the maintenance cartridge when cleaning it various is insufficient.03841101-2818 Maintenance cartridge not installed03841201-2816 Maintenance cartridge EEPROM error03841201-2817 Maintenance cartridge ID error03860002-2E0A Manually fed cut sheet was already loaded even though received data indicated roll media03861001-2405 The form set position is unsuitable to the print of edge none.03861001-2406 Data is unsuitable to the print of edge none.03862000-2E09 Roll paper running out03870001-2015 Cut errorE194-4034 Sensor calibration error(not generated in the user mode. )Code* DescriptionE141-4046 Recovery system rotation count reached 50,000.E144-4047 Feed system counting errorE146-4001 Borderless/idle ejection/mist recovery count fullE161-403E Abnormally high printhead temperatureE194-404A No ink ejection counting errorE196-4040 Checksum errorE196-4041 Flash memory clearing errorE196-4042 Flash memory write errorE196-4043 Main controller errorE196-4045 EEPROM write errorE196-4049 Forwarding ROM data machine kind differenceE198-401C RTC errorCode* Description