Chapter 44-544.5 Adjustment and Setup Items4.5.1 Adjustment Item List 0016-9220The following adjustment procedures need to be performed when parts have been replaced or remove and then reinstalled:T-4-14.5.2 Procedure after Replacing the Carriage Unit or Multi Sensor 0012-6486a) Multi Sensor RecalibrationSince multi sensors have individual electrical specificity, the following are recalibrated at the factory, namely, the optical axis of the sensor, the sensor gain formeasuring the printhead height and sensor reproduction. Accordingly, carry out the following adjustments in the service mode whenever replacing the carriage unitor multi sensor.- Service mode : SERVICE MODE > ADJUST > GAP CALIB.- Service mode : SERVICE MODE > ADJUST > PRINT PATTERN > OPTICAL AXISMedia type : Photo glossy paperMedia size : Media having a width equal toor larger then that of A2-size paperThe multi sensor reference plate must be replaced at the same time whenever the carriage or the multi sensor is being replaced.Adjustment item Adjustment timingMulti sensor recalibration Multi sensor replacement/removalCarriage unit replacement/removalAdjusting wire roller Wire guide replacement/removalCarriage unit replacement/removalHead management sensor recalibration Head management sensor replacement/removalCarriage unit replacement/removal
