[Maintenance] Viewing Current Settings, Event Logs and Performing Maintenance89Setting Page4e-mail when [Enable] is selected.For details on log messages, see [List of LogMessages] (p. 168).(2) [Notification Level]Select [Error], [Errors and warnings], or [All] for thelog message notification level.For details on log messages, see [List of LogMessages] (p. 168).(3) [Copy E-mail Settings]Copy the mail settings used in [Upload] > [E-mailNotification] (p. 68).(4) [Mail Server Name]Enter the host name or IP address of the SMTP server(using up to 63 characters).(5) [Mail Server Port]Enter the port number of the SMTP server (factorydefault setting is [25]).(6) [Sender (From)]Set the e-mail address of the sender (using up to 63characters).(7) [Recipient (To)]Set the e-mail address of the recipient (using up to 63characters).(8) [Authentication]Select [None], [POP before SMTP] or [SMTP-AUTH]for the e-mail authentication method.Set an appropriate method according to theauthentication method used by the SMTP server tosend to.[User Name], [Password], [POP Server]If [POP before SMTP] is selected as the e-mailauthentication mode, enter the user name andpassword as well as the host name or IP address ofthe POP server required for authentication.[User Name], [Password]If [SMTP-AUTH] is selected as the e-mailauthentication method, enter the user name andpassword required for authentication.(9) [Subject]Enter the subject of the e-mail to be sent using up to31 ASCII characters.(10)[Log Notification Test]Clicking [Exec] initiates a log notification test basedon the settings currently entered. It is not necessary toclick [Apply].After entering a password, first click [Exec], then[Apply] the password.
