Restore Default Settings181Appendix7There is no on/off switch on the camera. Turn thecamera on and off by plugging in or unplugging LANcable (PoE power supply), AC adapter, or externalpower plug.The reset switch is located in a recessed area. Pushthe switch using the tip of a slender object such as aclip.All settings of the camera, except for the date andtime, are restored to factory default settings.For dome case attachment, see the “InstallationGuide” included with the camera.2 Turn off the camera.3 Turn on the power while pushing the reset switch, andkeep pushing the reset switch for 5 seconds or more.ImportantIf the reset switch is pushed, network-related settings will alsobe restored to factory default settings including the camera's IPaddress, subnet mask, default gateway address, etc.Accordingly, you can no longer operate the camera from thePC you were using to connect to the camera before. Wheninitializing the camera, use the “Camera Management Tool”installed in your PC to set an IP address appropriate for theenvironment in which the camera is used (See “Making InitialCamera Settings” (p. 28)).Reset SwitchVB-H630VE/VB-M620VEReset Switch4 For VB-H630VE/VB-H630D/VB-M620VE/VB-M620D,attach the dome case.VB-H630D/VB-M620DReset SwitchReset Switch
