Performing Operations and Settings in the Admin Viewer1536 Admin Viewer/VB Viewer(1) [Haze Compensation][Auto]Automatically uses Compensation Removal.[Manual]Use buttons in (2) to manually set the compensationstrength.[Disable]Disables Haze Compensation.(2) Haze Compensation StrengthWhen Haze Compensation is [Manual], set one of the7 levels from [1] (Mild) to [7] (Strong).Note• When [Auto] or [Manual] is selected for [Haze Compensation],the video data size increases.• When using [Haze Compensation], contrast may be strong ifthe subject is not obscured by haze. If this happens, set [HazeCompensation] to [Manual] and set a lower HazeCompensation strength. Setting the Focus[Auto]:Automatically focuses on thesubject.[Manual] : You can adjust the focus manuallyby pushing the (far) and(near) buttons.Clicking [One-shot AF] will useautofocus to focus on a subject andthen stop in manual focus.[Fixed at Infinity] : You can set the focus so that it isfixed near infinity. Setting the Exposure(1) Exposure ModeSelect from [Auto], [Manual], [Auto (Flickerless)] or[Auto (Shutter-priority AE)].If [Auto] is selected for [Day/Night] under [Camera] inthe Setting page (p. 57), select [Auto], [Auto(Flickerless)] or [Auto (Shutter-priority AE)].[Auto]The exposure is controlled automatically.[Manual]The exposure is set by adjusting the shutter speed,aperture and gain values manually.[Auto (Flickerless)]In this mode, video flickering caused by fluorescentlights, etc., can be reduced. The shutter speed isautomatically adjusted according to the brightnessof the environment in which the camera is used.[Auto (Shutter-priority AE)]In this mode, the desired shutter speed can bespecified.ImportantIf you set [Smart Shade Control] to [Auto] or [Manual], [HazeCompensation] is set to [Disable].Important• If it is set in the Admin Viewer, the same focus mode willoccur in the viewers of other users also.• Depending on the lighting used, focus may not bemaintained when switching between [Day Mode] and [NightMode]. Focus when switching Day/Night Mode can be set inthe [Day/Night Mode Focus Settings] panel in the AdminViewer (p. 155).• Setting the shutter speed at [1/1 sec] in manual exposure(p. 153) will disable the [Auto] and [One-shot AF] focusmodes in Control for Admin. Switch the focus to [Manual] andadjust it to your subject.• Refer to the following for focus ranges.Notes on p. 58Notes on p. 42• Changes to focus mode in the Admin Viewer will not bereflected in the settings on the setting page.• Note that if you set the focus manually it will remain fixed.(1)(2)(3)(5)(6) (7)(4)
