Chapter 1 27Before Printing(3) Pinch the Paper Guide and slide it against the left side of the paper stack.z Loading EnvelopesUse either European DL or US Comm. Env. #10 size envelopes.The address is rotated automatically to match the direction of the envelope when printing.1 Load the envelope against the Cover Guide on the right side of the Paper Supportwith the front face UP, and the rear flaps DOWN on the left.Important Do not load the paper beyond this Load Limit Mark (A).Note z You can use general copy paper or Canon’s Super White Paper SW-201.z You can load up to 150 sheets of plain paper (64 gsm or 17 lb, 13 mmor 0.52 inches in height) in the Auto Sheet Feeder. However, the papermay not be fed normally depending on its media type or yourenvironment where the temperature and humidity are high or low. Inthat case, reduce the amount of paper to half (approx. 0.2" / 5 mm inheight).z Remove the printed sheets from the Paper Output Tray before thecount reaches 50.z Do not touch the printed surfaces until the ink dries. For specific dryingtimes, refer to the instructions packaged with your media.Important z Envelopes can be used only when printing from a computer.z Do not use envelopes with embossed or treated surfaces, a doubleflap, pressure seals or sticker flaps.z Select either [DL Env.] or [Comm. Env. #10] according to the envelopesize you are using.z If the print image is upside down when printing onto special envelopes,open the printer properties dialog box then select the [Rotate 180degrees] check box on the [Page Setup] tab.For information on the printer driver settings, refer to the Printer DriverGuide.(3)(2)(A)(1)
