Canon FAXPHONE L75 Service Manual

Also see for FAXPHONE L75: User guide Specifications Setup sheet Software user's guide

Contents

Canon FAXPHONE L75 Service Manual Manual pdf 144 page image

4-51LASER CLASS 1060P Chapter 4: Maintenance & Service4.2.5 New SSSWs/parameters added to this model#1 SSSW (service soft switch setting)SW01 (service soft switch 01: error management)Bit Function 1 00 Service error code Output Not output1 Error dump list Output Not output2 Enter password at confidential No YesRx image data transfer3 Copy function No Yes4 (New) ##300 series service error code Output Not output5 Not used6 Not used7 User setting restriction Setting possible Setting restricted[Bit 4]Even when Bit0 is set to “Not output”, you can select whether or not to output ##300 series ServiceError Codes, caused by hardware malfunction.When “Output” is selected, ##300 series Service Error Codes are displayed and included in reports.When “Not Output” is selected, no Service Error Codes are displayed.SW15 (service soft switch 15: Dial inn FAX/TEL switching function setting)Bit Function 1 00 Not used1 Not used2 Not used3 Not used4 Not used5 Not used6 (New) Delect continuous signal at Yes NoFAX/TEL switching7 Not used[Bit 6]You may enable or disable detection of ROT continuous signal for FAX/TEL switching.Normally, only ROT intermittent signals are detected for FAX/TEL switching. If you need to detectboth in view of exchange specifications, select “1” to enable detection.