General Problems9-36Troubleshooting9General ProblemsThe machine has no power.Q Is the power cord plugged in securely?A Check that the power cord is plugged securely into the machine and into thewall outlet. Insert the power cord straight into the power socket on the back ofthe machine. Do not insert it at an angle. Otherwise, the machine may not beproperly connected to the power source and may not turn on. If this happens,disconnect the power cord, and reconnect it correctly after a minute or more.(See the Set-Up Instructions for the Machine.)Nothing appears in the LCD.Q Is the power cord plugged in securely?A Check that the power cord is plugged securely into the machine and into thewall outlet. Insert the power cord straight into the power socket on the back ofthe machine. Do not insert it at an angle. Otherwise, the machine may not beproperly connected to the power source and may not turn on. If this happens,disconnect the power cord, and reconnect it correctly after a minute or more.(See the Set-Up Instructions for the Machine.) If the LCD remains blank, unplugthe machine and wait approximately 3 minutes to 5 minutes until thetemperature inside the machine lowers, then plug it in again. If the LCD remainsblank, unplug the machine, and contact Canon Authorized Service Facilities orthe Canon Customer Care Center.Q Does the Energy Saver key go off?A When the Energy Saver key lights up, the energy saver mode activates. Torestore the machine from the energy saver mode, press [Energy Saver].
