Paper Drawers1-161Routine MaintenancePaper which has been rolled or curled must be straightened out before loading it into the paper deck.Make sure that the height of the paper stack does not exceed the loading limit mark ( ) on the inside of the paper deck.Load the paper stack in stages, adding approximately 600 sheets of paper (17 lb bond (64 g/m²)) or 550 sheets of paper (20 lb bond (80g/m²)) at a time. If the paper deck can accommodate more paper, the lifter will descend.For instructions on loading transparencies, see “Loading Transparencies,” on p. 1-8.Hot air that is blown by the fan may warm the inner size change plate of the POD Deck Lite-A1.If there are instructions on the package of paper about which side of the paper to load, follow those instructions.When paper is loaded in the paper deck, the side facing up is the one printed on.If problems occur, such as poor print quality or paper jams, try turning the paper stack over, and reload it. However, you cannot turntextured or one-sided coated paper over. Change this paper instead.For more information on the print direction of preprinted paper (paper which has logos or patterns already printed on it), see Chapter16, "Appendix," in Getting Started.5 Lower the feeding support rollerIf the Paper Deck Unit-A1 is attached, proceed to step 6.6 Gently push the paper deck back into the machine until it clicks into place in the closed positionThe inside lifter automatically rises, and prepares the paper deck for feeding.When closing the paper deck, be careful not to get your fingers caught, as this may result in personal injury•••••••••
