60AppendixPrinthead and Ink TanksTurning Off the PrinterTo avoid printer malfunction always use the POWER button to turn the printer onand off. Never remove the power cord from the power outlet until you have turnedoff the printer by pressing the POWER button. After the POWER lamp goes out, youcan unplug the power cord from the power outlet.Using the Printer Near Appliances and Fluorescent LampsAllow at least 6 inches clearance between the printer and another appliance or afluorescent lamp. Electrical noise generated by a fluorescent lamp placed tooclose to the printer could cause the printer to malfunction.Regulatory InformationColor Photo Printer Model: K10207 (S820)This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user isFor safety, always store printhead and ink tanks out of the reachof small children. If a child accidentally licks or ingests any ink,consult a physician immediately.Never subject a printhead or ink tank to shocks or excessivevibration. Shaking could cause ink to leak and stain clothing andnearby surfaces.Never touch the printhead or electrical contacts on a printheadimmediately after removing it from the printer. These metal partsbecome very hot during printing and could cause minor burns.S820QSG.book Page 60 Thursday, October 18, 2001 1:41 PM