84Problem See PageOther Printing ProblemsStrange charactersPrint job halts before completionCharacters on the screen do not match printed charactersPrinting beyond edge of pageIrDA printing stops and paper is ejectedPrinter prints incorrect number of lines on a pageComputer indicates a device time-outPrintouts are incomplete (only 50% to 75% of the page) or printed with large whitebands9495969696969797Errors indicated by the CHARGE/ERROR lampCHARGE/ERROR lamp lights and stays on and buzzer beeps once.The printer could not feed the paper or special media correctly from the feed slot on the front of theprinter or from the optional sheet feeder. Hold the printer steady with one hand then pull the sheetfrom the printer slowly. Load the sheet straight into the printer, and press the RESUME button toclear the error condition.CHARGE/ERROR lamp lights and stays on and buzzer beeps twice.The printer could not eject the paper correctly because the paper is over 58 cm long (23 in.). Removethe paper. Break the print job into shorter pages. The printer cannot feed and eject paper longer than58 cm (23 in.).CHARGE/ERROR lamp lights and stays on and buzzer beeps three times.No BJ Cartridge is installed on the printer. Install a BJ Cartridge. (p28)CHARGE/ERROR lamp lights and stays on and buzzer beeps six times.The battery pack is not installed correctly in the printer. Press the POWER button to switch theprinter off and install the battery pack. (pl9) Press the POWER button to switch the printer on again.If the problem persists, replace the battery pack. (p62) To avoid problems with the battery pack,always use the printer within the correct temperature range of 0°C to 35°C (32°F to 95°F).84
