115BJ mode exampleThis part shows that the decimal form the command to specify condensed text is 15 and thecharacter form of the same command is SI. To access condensed (17 cpi) text in Lotus 1-2-3when you are in BJ mode, follow this procedure.Each number in the decimal form of the command must be three characters long, so you needto use a leading zero if the code is a two-digit number. A simple command might look likethis:\0771. In Lotus 1-2-3, type \PPOS to open the printer option setupmenu.2. To use the decimal form, type \O1 5 to specify condensed text.LQ mode exampleSuppose you are working in LQ mode and want to print text at 12 cpi. In Appendix B you see that thedecimal code for the command for 12 cpi is 27 77. Follow this procedure to specify 12 cpi printing inLotus 1-2-3.1. In Lotus 1-2-3, type \PPOS to access the printer option setup menu.2. To enter the code in decimal format, type \027\077. Be sure to insert the leading zeros beforethe numbers so they are both three digits.BJ mode command summaryAll of the control codes shown in the following tables can be used in the BJ mode.Because of hardware differences, the reverse feed code — ESC] and the printer deselect code — DC3 —are not supported by your printer. Also, the styles of block graphics characters at 12 cpi are differentfrom normal Proprinter X24E printing.115
