114Appendix CPrinter Command SummariesPrinter control codes are listed under each of the two printer control modes: BJ mode and LQ mode.Printer control codes tell the printer how to print a job.You can send commands in several ways:z You can use your software application to automatically embed certain commands (suchas bold, underline, or indent) within a document. Your software application usuallydisplays a symbol (such as B for bold) or changes the appearance of the displayed textto indicate the embedded commands. When the document prints, the embeddedcommands control the way the printer produces the printed page. See your softwareapplication manual for instructions on sending commands.z You can send specific commands directly to the printer, using either a BASICstatement or a printer command option in your software application.Entering a setup string in Lotus 1-2-3The procedure for entering printer control commands in Lotus 1-2-3 is typical of the procedures usedin spreadsheet software applications. If you are using another spreadsheet, review your applicationmanual to determine if your software application supports printer option setups. Although theprocedure to enter the codes may differ slightly, you will still have to enter the same number codes.For a list of these codes, refer to the tables later in this appendix.114
