Cal Spas LTR20101001 Owner's Manual

Also see for 2010 Series: Owner's manual Owner's manual

Contents

Cal Spas LTR20101001 Owner's Manual Manual pdf 12 page image

2010 Portable SpaLTR20101001, Rev. BOperating Your Spawww.calspas.com12Initial Start upWhen first powered up, it will automatically revert toPriming mode. A Pr on the topside display will indicatethis. Priming mode will be active for less than fiveminutes at which time the heater will be activated andthe water temperature will be maintained in Standardmode. The spa will heat to 37.5°C at start up until theset temperature is changed as described below.Temperature Adjustment(Range 26°C to 40°C)The electronic control panels display the actualwater temperature in degrees Celsius. The displayedtemperature will only be current after the pump hasbeen running for at least 2 minutes.To display the temperature that the spa is set to:Press the Temp button. The temperature•setting will flash.While the display is flashing, each time you•press Temp button, the set temperaturewill change up or down one degree.If the desired temperature is opposite•of the direction each press of the buttonis making, release button, allow displayto stop flashing and then press Tempbutton to change temperature the otherdirection.Standard, Economy and SleepHeating ModesYour new spa is equipped with a heating feature thatgives you complete control of the heating system.When the spa is powered up, it will automatically startin standard heating mode.St will light briefly on the main display. In this mode,•the heating system will automatically maintainthe set spa temperature. In the economy-heatingmode, the heating system will only activate duringfiltration times.Ec will display solid if temperature is not current•and will alternate with spa temperature if measuredtemperature is current.Economy mode will heat the water to the set•temperature while Sleep mode, indicated by aSL on the main display, will also only activate theheater during the filtering cycles but will only heatthe water to within 10°C of the set temperature.6105 and 6205 Electronic Control OperationOperating Your SpaLike Economy mode, SL will display solid whentemperature is not current and will alternate withactual temperature when it is current.NOTE: Displayed temperature will only be current afterthe pump has been running for at least two minutes.Switching ModesPress Temp button followed by the Light button.•Press the same sequence to switch to the next•mode.JetsPress the Jets button:Once to activate low speed pump.•Twice to activate high speed.•Three times to return to turn pump off.•