ENCORE LITE Rev. 3 05/2018www.cafection.com 800-561-616240SERVICE & INSTALLATION MANUAL for Cafection's Encore Lite Service Mode"Get a Sample" InterfaceA These buttons are used to get a sample of all the dry ingredients of the tested recipe, inthe desired strength.In order to weigh the ingredients, make sure to place a container under ALLproduct dispensers used for the tested recipe.B This button is used to get a sample of the recipe without the ingredients.Make sure to place a recipient large enough under the dispensing nozzle.C These buttons are used to get a sample of the entire recipe, in the desired strength.Samples are not registered in the sales counters.6.5.3 Liquids & Ingr. (Ingredients) Sub TabAll values used for the recipes are time values. The water quantity values representthe amount of time the dispensing water valve is opened. The coffee or solublequantity values represent the amount of time the motor is running.20 units = 1 second.The right section of the numeric keypad indicates an estimatedconversion of the value in units to a milliliter (ml) and to a US ouncefluid (oz) for liquids, or in grams (g) for the ingredients.1. This line indicates which recipe is being modified.2. This table is used to set the quantity of coffee required to brew the recipe, if applicable.3. These checkboxes are used to set the coffee used by default to make the coffee drink,if applicable.4. This checkbox is used to allow the customer to select the coffee of his choice, if applicable.5. This table is used to set the quantity of water required to brew the recipe.6. This table displays the recipe's brew cycle. It is automatically selected by the software.7. These tables are used to set the quantity of soluble powder required to brew the recipe, ifapplicable.8. This table is used to set the quantity of water mixed with the soluble powders, if applicable.9. This button is used to save any changes to the current recipe. Any unsaved changes will be lost.ABC123546789