Cafection Encore lite Service & Installation Manual

Contents

Cafection Encore lite Service & Installation Manual Manual pdf 18 page image

ENCORE LITE Rev. 3 05/2018www.cafection.com 800-561-616218SERVICE & INSTALLATION MANUAL for Cafection's Encore Lite4 INITIAL SETUPBefore the installation of the brewer on location, it is strongly suggested to unpack, inspect and bench testthe machine before it leaves the warehouse.4.1 On-Site Installation Requirements4.1.1 Operating EnvironmentEquipment is for indoor use only.4.1.2 Power SupplyMake sure each unit has its own electrical circuit and is located within 6 feet of thededicated electrical outlet.Use only a polarized grounded receptacle.Domestic 120 V AC / 60 Hz - 15 A circuit.4.1.3 Water SupplyUse a plastic 1/4” or 3/8” (outside diameter) dedicated line branched off a larger line. Aneasily accessible shut off valve up stream of the unit is highly recommended for ease ofinstallation.Cold tap water pressure should be at least 20 psi and no more than 80 psi.4.1.4 Tools Required- #2 Phillips screwdriver- Regular medium pliers- Adjustable wrench- Level indicatorOther tools may be required depending on the type of water supply tubing andlocation.4.1.5 ClearanceUnit Clearances Allowance forHeight 39 1/4” 45 1/4” Opening bean hopper.Width 11 5/8” 23 5/8” Accessing lock (left side) and opening door (right side).Depth 25 3/4” 37 1/2” Opening door (front) and back clearance.BackClearance2 1/2”6”Clearance for water hookup, hoses and adequate aircirculation.Needed only if a filtration system is installed behindthe machine.See Annex 4 for waste chute positioning.See Annex 5 for a diagram illustrating required clearance.Initial Setup