Cafection Encore lite Service & Installation Manual

Contents

Cafection Encore lite Service & Installation Manual Manual pdf 28 page image

ENCORE LITE Rev. 3 05/2018www.cafection.com 800-561-616228SERVICE & INSTALLATION MANUAL for Cafection's Encore Lite4.12 Installation VerificationIt is important to perform several brew cycles on the equipment before completing the installation. Atleast two (2) cups of each product selection should be ordered to ensure that the brewer is operatingas per the specifications laid out in this manual. During this process, review the following checklist as areminder. Make sure that the brewer is clean, safe and functioning once it is ready to be left on-site.What to verifyInlet valve is free of leaks. Verify that it is secured and not overtightened.Brew chamber is empty of coffee. Verify that the unit is leveled.Filter paper feeds without resistance and goesstraight into the waste bin.Verify that the chute is properly installed.Repeat the installation procedure, if needed.Soluble mixing bowl is free of leaks. Verify that it is installed straightand that the tube is secured.Water temperature is acceptable. Verify water temperature.Products are loaded. Load products.Brewer and area are clean and tidy. Clean and tidy up.Initial Setup4.13 Coin Changer and Bill AcceptorThe Encore Lite software and hardware are tested and developed using CoinCo products.Cafection recommends using the same brand for complete compatibility.The following models have been tested and work with the Encore Lite:- MDB Coin acceptor 9300GX(American coins)- MDB Coin acceptor 9300CGX(Canadian coins)- MDB Bill reader Bill Pro BP4-CRX6U - MDB Coin acceptor Guardian 6000- MDB Bill reader Bill Pro BP4SX(American bills only)Every bill inserted will be automatically placed into the bill stack, allowing the customer to insertmultiple bills in a single transaction. That is why a customer cannot cancel the transaction andhave the bill returned. If the transaction is canceled, the value of the bill inserted will be refunded incoins. Bills with a maximum value of $10 are accepted. Higher value bills will be returned.The brewer must be equipped with a functional coin changer in order for the bill acceptor to workproperly. A bill will only be accepted if the coin changer contains at least the same value in coins inits tubes.The coin changer issues coins of $0.05 or more. When setting products sellingprices, make sure to set amounts ending with a 5 or 0. For example, if a productis sold at $1.98 and the customer inserts $2, the coin changer will not be able toreturn the $0.02 due. The right selling price should therefore be set to $1.95 or$2.00.