65 . . .–Section 1EXITING PROGRAMMINGMODETo exit programming mode, doany of the following:• Turn off the ignition.• Press the driver informationcenter trip/fuel informationbutton or vehicle informationbutton.• Press the customizationbutton repeatedly until thefollowing message appears onthe display:- PRESS TO EXIT FEATURESETTINGS- Press the button to exit themenu.• Do not press any buttons.The display will time out after40 seconds of inactivity.Driver Information CenterMessagesThese messages will appear if aproblem is sensed in one of yourvehicle's systems or to displaysystem information.If there is more than one message,the messages will appear onebehind the other.Clear any warning messages onthe Driver Information Center bypressing any of the four DriverInformation Center buttonslocated on the instrument panel,to the right of the steering wheel.Clearing a message only makes themessage disappear. It does noteliminate the problem. Be sure totake messages seriously.Some messages may not becleared until the problem is fixed.• CALIBRATING: DRIVE INCIRCLESAppears when the compass isbeing calibrated.To calibrate the compass, driveyour vehicle in a 360° circle at aspeed of 8 km/h or less.See the following, earlier in thissection, for more information:- Vehicle Information MenuPRESS TO CALIBRATECOMPASSAKENG44_Escalade Page 65 Wednesday, July 16, 2008 12:22 PM
