Universal Home Remote SystemOperationDo not use the Universal Home Remote with anygarage door opener that does not have the stop andreverse feature. This includes any garage door openermodel manufactured before April 1, 1982. If youhave a newer garage door opener with rolling codes,please be sure to follow Steps 6 through 8 to completethe programming of your Universal Home RemoteTransmitter.Read the instructions completely before attempting toprogram the Universal Home Remote. Because ofthe steps involved, it may be helpful to have anotherperson available to assist you in the programming steps.Keep the original hand-held transmitter for use inother vehicles as well as for future Universal HomeRemote programming. It is also recommended that uponthe sale of the vehicle, the programmed UniversalHome Remote buttons should be erased for securitypurposes. See “Erasing Universal Home RemoteButtons” later in this section or, for assistance, seeCustomer Assistance Offices on page 7-5.Be sure that people and objects are clear of the garagedoor or gate operator you are programming. Whenprogramming a garage door, it is advised to park outsideof the garage.It is recommended that a new battery be installed inyour hand-held transmitter for quicker and moreaccurate transmission of the radio-frequency signal.Programming Universal Home RemoteFollow these steps to program up to three channels:1. Press and hold down the two outside UniversalHome Remote buttons, releasing only when theUniversal Home Remote indicator light beginsto flash, after 20 seconds. Do not hold down thebuttons for longer than 30 seconds and do notrepeat this step to program a second and/or thirdhand-held transmitter to the remaining two UniversalHome Remote buttons.2. Position the end of your hand-held transmitterabout 1 to 3 inches (3 to 8 cm) away from theUniversal Home Remote buttons while keeping theindicator light in view.3. Simultaneously press and hold both the desiredUniversal Home Remote button and the hand-heldtransmitter button. Do not release the buttonsuntil Step 4 has been completed.2-46
