Starting Your EngineMove your shift lever to PARK (P) or NEUTRAL (N).The engine will not start in any other position — that isa safety feature. To restart when you are alreadymoving, use NEUTRAL (N) only.Notice: Shifting into PARK (P) with the vehiclemoving could damage the transaxle. Shift intoPARK (P) only when your vehicle is stopped.1. With your foot off the accelerator pedal, turn theignition key to START. When the engine starts,let go of the key. The idle speed will go down as theengine gets warm.Notice: Holding your key in START for longer than15 seconds at a time will cause your battery tobe drained much sooner. And the excessive heatcan damage your starter motor. Wait about15 seconds between each try to help avoid drainingyour battery or damaging your starter.2. If the engine does not start within 10 seconds, holdyour key in START for about 10 seconds at a timeuntil the engine starts. Wait about 15 secondsbetween each try.When your engine has run for about 10 seconds towarm up, your vehicle is ready to be driven. Donot race your engine when it is cold.If the weather is below freezing (32°F or 0°C), letthe engine run for a few minutes to warm up.3. If your engine still will not start, or starts but thenstops, it could be flooded with too much gasoline.Try pushing your accelerator pedal all the way to thefloor and holding it there as you hold the key inSTART for about three seconds. If the vehicle startsbriefly but then stops again, do the same thing.This time keep the pedal down for five or sixseconds to clear the extra gasoline from the engine.After waiting about 15 seconds, repeat the normalstarting procedure.Notice: Your engine is designed to work with theelectronics in your vehicle. If you add electricalparts or accessories, you could change the way theengine operates. Before adding electrical equipment,check with your dealer. If you do not, your enginemight not perform properly.2-26
