Bosch Purion Performance Line BDU365 Owner's Manual

Also see for Active Line BDU310: Owner's manual Original operating instructions Owner's manual Manual Original operating instructions

English – 4Displays and configurations of theon-board computerBattery charge indicatorThe battery charge indicator (g) displays the eBike battery'sstate of charge. The state of charge of the eBike battery canalso be checked on the LEDs of the battery itself.In the indicator (g), each bar in the battery symbol repres-ents approximately 20 % capacity:The eBike battery is fully charged.The eBike battery should be recharged.The LEDs of the battery charge indicator on thebattery go out. The capacity for assisting the drivehas been used up, and assistance is gentlyswitched off. The remaining capacity is madeavailable for the lighting. The indicator flashes.The capacity of the eBike battery is enough forabout two hours of lighting.Speed and distance indicatorsThe speedometer (a) always displays the current speed.Indicator (i) always displays the last setting as standard. Re-peated medium-length presses of the button – will displaythe trip distance TRIP, the total distance TOTAL and therange of the battery RANGE one after the other. (Brieflypressing the button – will decrease the assistance level.)To reset the trip distance TRIP, select the trip distance TRIPand simultaneously press and hold the buttons + and –.The display will initially show RESET. If you continue to pressboth buttons, the trip distance TRIP will be set to 0.To reset the range of the battery RANGE, select the batteryrange RANGE and simultaneously press and hold the but-tons + and –. The display will initially show RESET. If youcontinue to press both buttons, the trip distance TRIP will beset to 0.You can switch the displayed values from kilometres to milesby holding down the button – and briefly pressing theon/off button (1).The versions of the subsystems and their model part num-bers can be displayed for the purposes of servicing,provided the subsystems divulge this information (depend-ent on the subsystem). With the system switched off, simul-taneously press the buttons – and + and then press the on/off button (1).The USB port is reserved for connecting diagnostic systems.The USB port does not have any other function.u The USB connection must always be completelysealed with the protective cap (8).Action Buttons DurationSwitch on on-board computerSwitch off on-board computerIncrease assistance +Action Buttons DurationDecrease assistance –Display TRIP, TOTAL, RANGE,assistance modes–Switch on bike lights +Switch off bike lights +Reset trip distance – +Activate push assistanceImplement push assistanceWALK+1.2. AnySwitch from kilometres to miles – 1. Keeppressed2.Display the versions A)B) – + 1. Keeppressed2.Adjust display brightnessC) – +– or +1. Keeppressed2.A) The eBike system must be switched off.B) The information is shown as scrolling text.C) The display must be switched off.1 207 020 XBP | (11.03.2020) Bosch eBike Systems22