Bosch Conettix D6600 Installation And Operation Manual

Also see for Conettix D6100IPv6: Manual Installation supplement

Contents

For example, 190.200.128.111 could be an IPv4 address and 2001:0db8:85a3:0042:0000:8a2e:0370:7334 could be an IPv6 address. Within an isolated network, you can assign IP addressesat random if each one is unique. However, connecting a private network to the Internetrequires using registered IP addresses (called Internet addresses) to avoid duplicates. IPv6addresses are typically set using DHCP on the network. The D6100IPv6 supports IPv4 and/orIPv6 addressing schemes or both at the same time.Identifying the MAC Hardware AddressYou must program the IP address of the module. The first step is to determine the MAC, orhardware, address of the module. This address is hard-coded into the module during itsmanufacture and cannot be changed. This address is 6 bytes (12 digits) long.Figure 12.6: MAC Address Label ExampleiNotice!The MAC address label is located on the rear of the module below the Ethernet port.Record this number for future reference.Obtaining an IP AddressProvide the module’s MAC address to the site’s network administrator, who then assigns an IPaddress for the D6100IPv6.Using the D6200 to configure the D6100IPv6Read this entire section before proceeding.iNotice!In order to access the configuration program, ensure that the D6100IPv6 and the computerused to configure it are directly connected using an Ethernet cable.Be sure that the computer being used to configure the device is configured to use DHCP toobtain an IP address. When it is connected directly to the D6100IPv6 obtains an AutoIP ad-dress.The D6200 software is the recommended way to program the network devices. Review theNetwork Utilities section in the D6200 Programming Software Operation and Installation Guide(P/N: 4998154991).1. When you have the IP address and the network administrator confirms that it is ready,connect the Ethernet port of the D6100IPv6 directly to the computer Ethernet port usingan Ethernet cable.2. With the computer already booted and running, apply power to the D6100IPv6 and waitapproximately 1 minute for the computer and D6686 to acquire an AutoIP address(169.254.xxx.xxx).3. Open the D6200 software and select Network – Network Utilities - Network DeviceSetup.12.4.212.4.312.4.458 en | Network Communications Conettix Communications Receiver/Gateway2012.11 | 08 | 4998122704 Installation and Operation Guide Bosch Security Systems, Inc.