Bosch Conettix D6600 Installation And Operation Manual

Also see for Conettix D6100IPv6: Manual Installation supplement

Contents

InstallationiNotice!Refer to the appropriate Installation Supplement included with your product for the specificsof your particular installation.Installation Check ListCheck each receiver card to see that it is correctly positioned in the card guides at thetop and bottom of the enclosure. Also confirm that connections did not loosen duringshipment (D6600 only).Check each receiver card to see that it is correctly positioned in the card guides at thetop and bottom of the enclosure. Also confirm that connections did not loosen duringshipment (D6600 only).Ensure that the earth ground is connected and grounded through the AC inlet.If you are installing additional line cards, install the terminator cards now (D6600 only).After installing additional line terminator cards, install the line cards (refer to CardInstallation, page 20).Install the line terminator card(s) from your spares package(s). If there is a malfunction,you can quickly switch over to the replacement card (refer to Card Installation, page 20).iNotice!You can install spare line terminator cards. Do not install spare line cards.Connect four or six conductor telephone cord(s) to the RJ11C jack(s) of the desiredtelephone line(s). Plug the other end of the modular telephone cord(s) into the telephone jackon the appropriate line terminator card(s).Connect the supplied AC transformer wiring leads to the AC terminals on the rear of theD6100IPv6.Plug the AC cord (D6600 only) into a correctly wired 120 VAC, 60 Hz or 220 VAC, 50 Hzoutlet (standard AC outlet).iNotice!Maintain a 6.5 mm (0.25 in) gap, or greater, between power limited and non-power limitedcircuit wiring.Plug the AC transformer into the correctly wired wall receptacle that matches the voltageof the transformer.88.1Conettix Communications Receiver/Gateway Installation | en 25Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704