11.2 Normal Operation Mode 3511.3 Operating in Manual Mode 3511.4 Keypad Menu Operation 3611.4.1 Log In 3611.4.2 Using the Keypad 3611.4.3 Event Buffer Display 3611.4.4 Current System Trouble Display 3611.4.5 Software Version Display 3711.4.6 Keypad Functions 3711.5 Busy Seconds (Line Busy) Reports 3811.6 Two-Way Audio 3911.6.1 Enhancements and Changes 4011.6.2 Two-Way Auto Modes of Operation 4012 Network Communications 4212.1 Conettix D6600/D6100IPv6 Pre-installation Requirements 4612.1.1 Setting Up the Conettix D6600/D6100IPv6 over an Ethernet Network 4612.1.2 Host Computer for Conettix D6600/D6100IPv6 System Setup 4612.2 Operation 4612.2.1 Setting Up the Host Computer 4612.2.2 Network Failover Solution (D6600 Only) 5112.2.3 Conettix Datagram Type Differences 5312.2.4 Networking and Encryption 5412.3 Special Conettix D6600 Applications 5612.4 D6100IPv6 Configuration Setup Instructions 5712.4.1 Factory Default IP Address 5712.4.2 Identifying the MAC Hardware Address 5812.4.3 Obtaining an IP Address 5812.4.4 Using the D6200 to configure the D6100IPv6 5812.4.5 Configuring for Network Communication 6312.5 D6100i Configuration Setup Instructions 6412.5.1 Identifying the MAC Hardware Address 6412.5.2 Obtaining an IP Address 6412.5.3 Initial IP Address Assignment Using ARP.EXE 6512.5.4 Using Telnet to Finish the Configuration 6612.5.5 Configuration Using Telnet 6712.5.6 Configuring for Network Communication 7013 No Data Received Reports 7213.1 No Data Received 7213.2 Data Error 7213.3 Wrong Data 7214 Central Station Automation System 7315 Central Station Tips 7515.1 Back-up Receiver 7515.2 Computer Interface 7515.3 D6200 Programming Software 7515.4 Telephone Lines 7515.5 Proper Ground 7515.6 Radio Frequency Interference 7615.7 Test Communicator 764 en | Table of Contents Conettix Communications Receiver/Gateway2012.11 | 08 | 4998122704 Installation and Operation Guide Bosch Security Systems, Inc.