Barco XDL-4K75 User Manual

Also see for XDL-4K30: Installation manual User manual

Barco XDL-4K75 User Manual Manual pdf 47 page image

6. GUI – Source6. GUI – SOURCEAbout the Source menuThis menu is used to select, review and configure sources into the projector.Overview of features• Displaying a single source• Displaying multiple sources: Stitched layouts• Connector Settings6.1 Displaying a single sourceAbout selecting a sourceBefore a source can be projected, the source signal must be connected to the source input(s) of the device and a valid synchroniza-tion signal must be available along with the source signal on at least one of the input connectors.How to select?1. Press Menu to activate the menus and select Source.Image 6-1Select Source2. Press OK.The Select Source menu is displayed with the actual available sources filled out.3. Select the desired input.6.2 Displaying multiple sources: Stitched layoutsAbout stitched layoutsThe first time you use a selected single source, the source will be displayed in the projector’s native resolution. If the resolution ofthe source is different to the projector’s resolution, the image is stretched or shrunk.It is however possible to configure and display two or four source signals to make up one single image in full native resolution. Thisis called a Stitched Layout: the sources are stitched together.The following table lists which stitched layouts you can use, and in which display mode these layouts can be used.The table below describes the different Stitch Layouts and scan directions.Type of layout Description Available connectors Mode1: SingleA single source is displayed in fullscreenQuad Combo input:• SDI (4x)• HDBaseT (2x)• DisplayPort• HDMIQuad DP 1.2 Input:• DisplayPort (4x)Mono / Active stereoR5906151 XDL 17/04/2018 43